How to Install LED Tube Lights

Mar 29th, 2012 | Posted by | Filed under LED Light

LED () tube lights are soon advancing to become the forefront of traditional lighting, that consist of fluorescent tube lights and CFLs (Compact Fluorescent Lamps). have a low luminous intensity, therefore they offer better distribution of light as compared to other sources of light and the intensity of glare too is reduced to a greater extent. They are energy efficient and more durable than other traditional sources of light, hence it makes sense to save in frugal electricity bills and replacement costs. LED lighting works on the lines of green technology, that is they create less carbon emissions and do not contain toxic mercury or any hazardous elements. Moreover, you don’t have to worry about getting the entire wiring system changed; a few simple modifications in the existing fixtures will serve the purpose. So, the next time you happen to change your existing tube light, make sure you consider installing .

Installing LED Tube Lights

* When you get started with installing LED tube lights in place of fluorescent tube lights, you will realize there are three main components; the ballast, the starter and the tube light that you have to get rid off. Now, the starter may not be a separate component in the entire circuit and is sometimes built in the ballast itself.
* Remove the old bulbs from the fixtures and make sure the electricity or the mains to the whole fixture is turned off while doing so. You may need simple tools like screw drivers, wires, wire stripper and cutter, some nuts and bolts; keep them all handy.
* Once the old bulbs or tube lights are taken off you will have to remove the reflector that encloses the wiring and the ballast as well. Usually, it is simple to detach the reflector, you may use the screw driver to remove this, in case it is fixed using screws otherwise you can use a wire stripper to just pull out the reflector.
* Now, you have to get rid of the ballast and starter (if present). The ballast will have two screws holding it, just unscrew them using a screw driver and dispose it off. While doing so, the wiring attached to it would also be removed. Reconnect the wires in the fixture so as to complete the circuit.
* You are practically there! Fix the reflector back again in its area covering the wiring work and insert the LED tube lights inside the sockets. Now, in spite of the reality that inserting the LED tube lights you must can be found to be good inside the best and bottom ends, and need to can be found to be repaired in to the circuit likewise. in situation you are unable to determine the best and bottom refer toward directions handbook supplied in the manufacturer.
* when you are achieved with installing the LED tube brightness inside the fixture, turn inside the mains or electricity. If all the connections are proper as well as the fittings are achieved inside the proper manner, you will possess a much better illumination. Your job does not complete here, it is vital which you dispose away the outdated fluorescent bulbs or tube lights properly according toward neighborhood regulations. Since, these bulbs consist of tiny quantities of toxic mercury, which have been completely extremely hazardous.